Nail board B and wooden blocks C and D onto board A about 5 x 5 inches. Push an iron bolt through a hole bored in B. Wind covered copper wire G 100 times round the bolt and connects the ends to a battery and to H respectively. Bore a hole through block C and wedge the fret saw blade H firmly into it so that its end is a short distance from bolt F. Hammer a long nail K through A and bend it so that its point rests in the middle of the saw blade. Oil the point of the nail. Use a piece of beading E as a key, with a rubber band P as spring and drawing pins M and N as contacts. Join all the parts with connecting wire remove the insulation. If you press the key down, you connect the electric circuit, bolt F becomes magnetic and attracts. At this moment the circuit is broken at K and the bolt loses its magnetism. H jumps back and reconnects the current. This process is repeated so quickly that the saw blade vibrates and produces a loud buzz. If you wish to do Morse signalling with two pieces of apparatus, you must use three leads as in the lower circuit diagram.